Xerox ii LINXSolid Inkjet 100 Service Manual

Also see for Nuvera 100: System guide Getting started Install guide Software guide Planning guide

Contents

Xerox ii LINXSolid Inkjet 100 Service Manual Manual pdf 55 page image

General Information 1-55Ink LoaderThe ink loader consists of four parallel channels with an ink meltingelement at the end of each of the four channels. (Refer to Figure 1-23.)Ink sticks, one color loaded in each channel, are pressed by coil-springpressure into the melting elements. As ink is required by theprinthead, the appropriate color’s melting element is activated andthe end of the ink stick is melted. The melted ink drips into the inkreservoirs of the printhead underneath. Sensors in the ink loaderalert the customer to install more ink sticks before the current sticksare completely consumed.If the ink level sensors inside the printhead detect that the printheadhas run out of ink, but the ink low/out sensors are not activated, thefront panel reports an “Ink Jam” error.Ink loader doorInk stickCoil springInk lowsensorInk outsensorPrintheadInk meltunits840-4-46Figure 1-23. Ink Loader