2-23Phaser 3635MFP 07-230, 07-231Status Indicator RAPsDraft 4• Tray 2 assembly, PL 8.15 Item 28.b. Perform OF7 Main PWB Check RAP.07-231 Check the Tray Feed Area RAP07-231 The machine has detected that paper is jammed in the tray 2 paper feeding area atpower on.ProcedureWARNINGSwitch off the electricity to the machine. Disconnect the power cord from the customersupply while performing tasks that do not need electricity. Electricity can cause death orinjury. Moving parts can cause injury.NOTE: The front cover assembly interlock switch must be closed to supply +24V to the motorsand clutches.Refer to Wiring Diagram 11. Perform the following:1. Pull out tray 2. Remove all jammed paper.2. Remove the pickup roll assembly, PL 8.17 Item 31. Check that the pickup roll is clean. Ifnecessary, install a new pickup roll assembly, PL 8.17 Item 31.3. Enter dC330 code 08-920 to run the tray 2 feed motor.4. Check the wiring between the tray 2 feed motor and CN8 on the Tray 2 PWB.5. While the tray 2 feed motor runs, stack the code 08-820 to energize the tray 2 pickupclutch (CL08-820). Check that the tray 2 pickup roll assembly, PL 8.17 Item 31 and feedroll, PL 8.17 Item 12 rotate. Install new components as necessary, PL 8.17.6. Check the wiring between the tray 2 pickup clutch and CN11 on the Tray 2 PWB.7. If necessary, install new components:• Tray 2 feed motor, PL 8.15 Item 23.• Tray 2 PWB, PL 8.17 Item 25.• Tray 2 assembly, PL 8.15 Item 28.
