Xomax XM-2RSU418BT Owner's Manual

Contents

Xomax XM-2RSU418BT Owner's Manual Manual pdf 12 page image

12Owner’ Manual1. Tuning the unit On / OffPress POWER button to turn the uniton. Press again to turn the unit off.2. Mode SelectionPress the MODE button to cyclethrough different play modes.3. Loudness ControlPress the SEL Button repeatly un-til the display shows “LOUD ON” or“LOUD OFF”. Rotate the VOL buttonto adjust. When “LOUD ON” shownon the display indicates that loudnessfunction is on.4. Mute ControlPress the MUTE Button to activatethe Mute function. Press the buttonagain to cancel.5. VolumeRotate the VOL Button to adjust thevolume level. Turn the button clock-wise to increase the volume, and viceversa. The larger the number of vol-ume, the higher the volume level.6. BassPress the SEL Button repeatly untilthe display shows “BAS”. Rotate theVOL button to adjust. When DSP isON, bass control is not available.7. TreblePress SEL Button repeatly until thedisplay shows “TRE”. Rotate the VOLButton to adjust. When DSP is ON,treble control is not available.8. BalancePress SEL Button repeatly until thedisplay shows “BAL”, then Rotate theVOL Button to adjust the balance be-tween the left & right speakers. When“L=R” is shown on the screen, it indi-cates that the balance is 0.9. FaderPress SEL Button repeatly until thedisplay shows “FAD”, Rotate the VOLButton to adjust the balance betweenthe front & rear speakers. When “F=R”is shown on the screen, it indicatesthat the fader is 0.10. Preset Equalizer FunctionPress SEL Button until the displayshows “EQ” ,then use button tochoose the EQ sound effects. TheSequence of equalizer setting will beas follows:FLAT-CLS-ROCK-POP11. Beep FunctionPress SEL button repeatly until the“BEEP” shown on the screen. Rotatethe VOL Button to choose “BEEPOFF” or “BEEP ON”. “BEEP OFF”means Beep function is inactive.“BEEP ON” means beep sound will beheard when any button pressed.12. Preset VolumePress and hold the SEL Button for2 seconds, the “TA ALLARM” will beshown on the screen. Press the SELButton repeatly until the “P-VOL”shown on the screen. Rotate the VOLButton to choose the volume levelwhich will be kept as preset when theunit is turned on.13. ClockThe time clock can be set anytimewhen the power is on. Press CLKButton, the time will be shown on thescreen. In FM model, press and holdthe CLK button until the “clock” blinkon the display. While listing to themusic, press CLK button once, the“clock” will blink on the display.1. Press >>| button to adjust the“hour”, and Press |<< button to adjustthe “minute”.2. Press “CLK” Button, or leave it idleto confirm the time setting.Basic Operation