Xterra TR3.0 Owner's Manual

Also see for Trail Racer TR3.0: Owner's manual Operating manual

Contents

Xterra TR3.0 Owner's Manual Manual pdf 18 page image

16TR3.0 Treadmill1. Select User 1 or User 2 via the Program key then press Enter. Note that the dot matrix willshow a single row of dots at the bottom of the display (Unless there is a previously storedprogram).If there is a program stored under the key that is pressed, it will be retrieved. If not, youhave the option of programming in your first name. The Display will flash the letter ”A” . Tochange it, press the 5 key, then “B” will be displayed; if the 6 key is pressed, the letter“Z” will be displayed. After selecting the appropriate letter, press enter. The letter “A” willagain be displayed and blinking. Repeat the procedure until all letters of your first nameare programmed (7 characters maximum). When your name is displayed, press Stop andit will be stored under either User 1 or User 2.2. If Enter was pressed, the Display will now be blinking a value, indicating your Age (defaultis 35). Entering your correct age affects the Heart Rate Bar Graph Display and the HeartRate programs. Use the 5/6 keys to adjust, then press Enter. (Note: You may pressStart at any time during the programming to start the program.)3. The Display will now be blinking a value, indicating your Body Weight (default is 150 lbs.).Entering the correct body weight will affect the calorie count. Use the 5/6 keys to adjust,then press Enter.4. The Display will be blinking a value, indicating Time (the default value is 30 minutes). Youmay use any of the 5/6 keys to adjust the time. After adjusting, or to accept the default,press Enter. (Note: You may press Start at any time during the programming to start theprogram).5. The Display will now be blinking the preset top speed of the selected program (0.5 mph or0.8 kph). Use the Speed 5/6 keys to adjust, then press Enter. Each program has vari-ous speed changes throughout; this allows you to limit the highest speed the program canreach.6. The Display will be blinking the preset top incline of the selected program (0%). Use theIncline 5/6 keys to adjust, then press Enter.You are now done programming data and may press Start to begin your workout or Enter togo back one level to change data entered in the programming phase.User Programs