|
20 E-mail: sales@xtramus.comWebsite: www.Xtramus.comXTRAMUS TECHNOLOGIES®A. NuTAP-311 HyperTerminal Command – systemCommand Descriptions – systemsystemshow The system show allows you to view NuTAP-311’s PCB/firmware/FPGA versions, aswell as hardware temperature.usershow The system user show command allows you to view the currentusers and their passwords.adminThe system user admin [name | password] command allows you to change the user name and its password of theuser with administrator privilege. For example, if you type in systemuser admin name test123 and press enter, a user named test123with administrator privilege will be created.guestThe system user guest [name | password] command allows you to change the user name and its password of theuser with guest privilege. For example, if you type in system userguest name test123 and press enter, a user named test123 withguest privilege will be created.devnameshow The system devname show command allows you to view the devicename assigned to NuTAP-311.set The system devname set [device name] command allows you toview the device name assigned to NuTAP-311.snmpshow The system snmp show command will show the current SNMP(Simple Network Management Protocol) settings.writecommunityThe system snmp writecommunity allows you to setthe community with write privilege. The can be public,private, or user names.readcommunityThe system snmp readcommunity allows you to setthe community with read privilege. The can be public,private, or user names.save The system save command allows you to save the current settings to NuTAP-311’sNV-RAM. Please note that all unsaved settings will be lost after system reboot.update firmware/FPGAThe system update [firmware/FPGA] commands allow you toupgrade NuTAP-311’s firmware/FPGA. The following descriptions arefor upgrading NuTAP-311’s firmware. However, procedures forupgrading NuTAP-311’s FPGA are quite the same and can be related.1. Type in “system update firmware” and click enter. Press Y toproceed and start upgrading firmware, or press N to cancel.2. Press Transfer on HyperTerminal’s menu bar and choose “SendFile”.
|
