37 E-mail: sales@xtramus.comWebsite: www.Xtramus.comXTRAMUS TECHNOLOGIES®6.2. Quick Launch ButtonsThese Quick Launch Buttons allow you to reconnect NuTAP-311, view counter/USC (Universal StreamCounter) statistics and chart, set packet capturing criteria, and make Network Port A0/A1, Monitor PortA0/A1 and system configurations. Please refer to the section down below for more detail descriptionsregarding to Quick Launch Buttons.6.2.1. ReconnectFunction Descriptions – ReconnectIf the connection between your PC and NuTAP-311 is down, a “Disconnected” iconwill be shown in “System Connection Status”.Press Reconnect button to re-establish the connection between your PC andNuTAP-311. If the connection has been established successfully, a message window will popup, and the “System Connection Status” will be shown as “Connected” .6.2.2. CounterFunction Descriptions – CounterThe Counter Report button located on the Quick Launch Buttons allows you to viewNetwork Ports and Monitor Ports’ counter reports and charts on the Main Display Screen.You can save the test statistics here as well. For more detail information, please refer to 6.7.Counter Report.6.2.3. USC (Universal Stream Counter)Function Descriptions – USCEach of NuTAP-311’s Network Port supports two sets of Universal Stream Counter (USC).The USC button located on the Quick Launch Buttons allows you to view USC statistics onthe Main Display Screen. You can save the USC statistics here as well. For more detailinformation, please refer to 6.8. Universal Stream Counter (USC) Report.6.2.4. Cap, A0/A1Function Descriptions – Cap, A0/A1The Cap, A0/A1 buttons located on the Quick Launch Buttons allow you to capturepackets flowing through Network Port A0/A1. For detail description regarding to thisfunction, please refer to 6.1.3. Report, Capture Network Port A0/A1 Packets.