YASKAWA Varispeed F7 User Manual

Also see for Varispeed f7: Connection manual Programming manual User guide Instruction manual User manual

101 OverviewThe SI-T Card is an interface card that connects to the MECHATROLINK-I orMECHATROLINK-II high-speed field network for communicating with the host controller.By installing the SI-T Card to a Varispeed G7/F7-series Inverter, various applications areenabled; monitoring of the run/stop status and the operating conditions as well as the changingand the referencing of the settings for the Inverter constants from the host controller.The SI-T Card can be installed in the following Inverters.• Varispeed G7-series Inverter, software No. 656X.• Varispeed F7-series Inverter (SPEC:E or later), software No.103X.Note: “X” indicates the design revision order.Varispeed G7/F7 Inverter with an SI-T Card does not conform to CE Marking, although the VarispeedG7/F7 Inverter itself conforms to CE Marking.2 Checking the ProductCheck the following items as soon as the product is delivered.Contact your Yaskawa representative immediately if any failure should be found concerning theabove items.2.1 Type and Code No.The following shows the type and code No. on the center of the SI-T Card.Type: SI-TCode No.: ETC61862X-S016XNote: “X” indicates the design revision order.IMPORTANTItem MethodIs there any discrepancy between the shipment andwhat was ordered?Check the type and code No. printed on the center of theCard. (Refer to 2.1 and 3.1.)Has the product been damaged in any way? Inspect the entire exterior of the Card for any damage thatmay have occurred during shipping.Are the contents of the package correct? Check the contents shown in the following table. (Refer to2.2.)