Yaesu FT-2000 Operating Manual

Also see for FT-2000 - MENU MODE LIST: Operating manual Operating manual Errata Reference book Brochure & specs

Contents

Yaesu FT-2000 Operating Manual Manual pdf 91 page image

Page 89FT-2000D OPERATING MANUALCW C ONVENIENCE F EATURESCHECKING THE CW MEMORY CONTENTS1. Be sure that Break-in is still turned Off by the [BK-IN]button.2. Press the [MONI] button to enable the CW monitor.3. Press the [F1(CH1)] ~ [F4(CH-4)] button to checkyour work. You will hear the results in the sidetone,but no RF energy will be transmitted.NOTE:Adjust the monitor level using the [MONI] knob.CONTEST M EMORY K EYER[F1(CH-1)] ~ [F4(CH-4)] Button[BK-IN] Button[F1(CH-1)] ~ [F4(CH-4)] Button[BK-IN] ButtonON-THE-AIR CW MESSAGE PLAYBACK1. Press the [BK-IN] button to enable transmission. Ei-ther Full- or Semi-break-in will be engaged, depend-ing on the setting of Menu item “058 A1A BK-IN.”2. Press the [F1(CH1)] ~ [F4(CH-4)] button to transmitthe programmed message.NOTE:If you subsequently decide to use the “Text Memory” tech-nique for memory storage, please note that the contents ofa message stored using keyer paddle input will not be trans-ferred over when you select “Text Memory technique” ona particular memory register (the Menu Mode Setting isset to “tyP1”).Transmitting in the Beacon ModeIt is possible to transmit, repetitively in a “Beacon” mode, any message programmed either via paddle input or viathe “Text” input method. The time delay between message repeats may be set anywhere between 0 and 255 secondsvia Menu item “017 tEy BEACON.” If you do not wish the message to repeat in a “Beacon” mode, please set thisMenu item to “off.” Press the [F1(CH1)] ~ [F4(CH-4)] button, depending on the register into which the Beaconmessage is stored. Repetitive transmission of the Beacon message will begin. Press one of these keys once more tohalt the Beacon transmissions.