Yaesu FT-65R Advance Manual

Also see for FT-65E: Instruction manual Operating manual Operating manual Quick manual Quick start guide

26ARTS™ (Automatic Range Transponder System)FT-65R/FT-65E Advance Manual4. Press the [▲] or [▼] key to select “BEEP”, thenpress the F key to enable adjustment of the ARTSAlert Beep options.5. Press the [▲] or [▼] key to select one of the options described above.6. Press the PTT switch to save the new setting and return to normal operation.CW Identifier SetupThe transceiver may be programmed to send a CW identification (“DE (your callsign)K”) every ten minutes during ARTS operation. The callsign field may contain up to 6characters.1. Press and hold the F key to enter the Set mode.2. Press the [▲] or [▼] key to select Set Mode Item “9 CW ID”.3. Press the F key to enable adjustment of this Set Mode Item.4. Press the F key, then press the [▲] or [▼] key toselect “TX : ON”5. Press the F key to save the new setting.6. Press the [▲] or [▼] key to select the “ID”.7. Press the Alphabet/Numeric keys to input the callsign.• After inputting a character of the callsign, press the [▲] key to move the cursor to thenext character position.• To correct a mistake, press the [▼] key repeatedly until the cursor returns to thecharacter position.To check the work by monitoring the callsign, press the MONI/T.CALLkey.8. When you have finished entering the entire callsign and it contains less than 6 char-acters, press and hold the F key to save the callsign.9. Press the PTT switch to save the new setting and return to normal operation.To monitor and check the entered callsign, repeat steps 1 - 6 above,then press the MONI/T.CALL key.