Yaesu FT-857D Operating Manual

Also see for FT-857 series: Manual Technical supplement Operation manual Brochure & specs Technical supplement

Contents

Yaesu FT-857D Operating Manual Manual pdf 77 page image

75FT-857 Operating ManualSplit-Frequency Memory StorageYou can also store “Split” frequencies, such as when operating on a repeater system not utiliz-ing a “standard” offset. This procedure may also be used for DX work on 7 MHz SSB, etc.1. In the VFO mode, set the desired Receive frequency and mode.2. Press the [FUNC] key momentarily, then rotate the SELECT knob, as needed, untilMulti Function Row “b” [MW, SKIP, TAG] appears on the display.3. Press the [A](MW) key momentarily to enter the “Memory Check” mode, which is usedto find an unused memory channel. The Memory Channel Number notation at the upperleft corner of the LCD will blink, and the frequency stored (if any) on the selected memorychannel will be shown in the display. Rotate the SELECT knob to select the channel onwhich you wish to store the receive frequency data.4. Press and hold in the [A](MW) key for one second until you hear two beeps (a secondapart), which confirms that the Receive frequency data is now stored.5. Now, set the desired Transmit frequency and mode on the VFO.6. Press the [A](MW) key momentarily; do not rotate the SELECT knob!7. While the Memory Channel Number is blinking, press and hold in the PTT switch; whileholding it in, press and hold in the [A](MW) key for one second.8. The two beeps will confirm that independent Transmit frequency data is now stored. Youmay now release the PTT switch.In step 7 above, pressing the PTT switch does not activate the transmitter. It sim-ply sends a signal to the microprocessor that an independent Transmit frequencyis being stored on the same channel as a previously-stored Receive frequency.MEMORY OPERATIONMEMORY OPERATION ON “REGULAR” MEMORY CHANNELS