Yaesu FT-8800R Operating Manual

Also see for FT-8800: Brochure & specs Reference Programming manual Quick guide

38 FT-8800R Operating ManualThe FT-8800R allows you to scan just the memory channels, the entire operating band, ora portion of that band. It will halt on signals encountered, so you can talk to the station(s) onthat frequency, if you like.Scanning operation is basically the same in each of the above modes. Before you begin, takea moment to select the way in which you would like the scanner to resume scanning after ithalts on a signal.Setting the Scan-Resume TechniqueTwo options for the Scan-Resume mode are available:TIME: In this mode, the scanner will halt on a signal it encounters, and will hold there forfive seconds. If you do not take action to disable the scanner within five seconds, thescanner will resume even if the stations are still active.BUSY: In this mode, the scanner will halt on a signal it encounters. Two seconds after thecarrier has dropped because the other station(s) ceased transmission, the scannerwill resume.To set the Scan-Resume mode:1. Press the [SET] key momentarily to enter the Set mode.2. Rotate the “Main” band DIAL knob to select Menu #34 (SCAN).3. Press the “Main” band DIAL knob momentarily, then rotate the “Main” band DIAL knobto select the desired scan-resume mode.4. Press and hold in the “Main” band DIAL knob for 1/2 second to save the new setting andexit to normal operation.Note: The default condition for this Menu Item is “TIME.”S CANNING