Yaesu FT-8800R Operating Manual

Also see for FT-8800: Brochure & specs Reference Programming manual Quick guide

66 FT-8800R Operating ManualMENU (“SET”) M ODEMenu #34 [SCAN]Function: Selects the Scan-Resume mode.Available Values: TIME/BUSYDefault: BUSYTIME: The scanner will halt on a signal it encounters, and will hold five seconds. If you donot take action to disable the scanner within five seconds, the scanner will resumeeven if the stations are still active.BUSY: The scanner will halt on a signal it encounters. Two seconds after the carrier hasdropped because the other station(s) ceased transmission, the scanner will resume.Note: This Menu Item can be set independently for each band.Menu #35 [SCAN M]Function: Selects the Memory Scan modeAvailable Values: MEM/MSMDefault: MEMMEM: Enables Memory Scanning on all memory channels.MSM: Enables Memory Scanning on “flagged” Memory Channels only.Menu #36 [SHIFT]Function: Sets the magnitude of the Repeater Shift.Available Values: 0.00 - 99.95 MHz (50 kHz step)Default: Depends on the band of operation.Note: This Menu Item can be set independently for each band.Menu #37 [SKP.MSM]Function: Selects what action will happen on a “flagged” Memory ChannelAvailable Values: OFF/SKIP/MSMDefault: OFFOFF: All memory channels will be scanned (the “flag” will be ignored).SKIP: The scanner will “skip” the flagged (“SKIP”) channels during scanning.MSM: The scanner will “only scan” the flagged (Preferential) channels during scanning.Menu #38 [STEP]Function: Sets the Synthesizer steps.Available Values: 5.0 k/10.0 k/12.5 k/15.0 k/20.0 k/25.0 k/50.0 kDefault: Depends on the band of operation.Note: This Menu Item can be set independently for each band.