Yaesu FT-8900R Operating Manual

Also see for FT-8900R: Brochure & specs Technical supplement Operating manual

61FT-8900R Operating ManualMenu #7 [CWID]Function: Enables/disables the CW identifier during ARTS operation.Available Values: TX ON/TX OFFDefault: TX OFFMenu #8 [CWID W]Function: Stores your callsign into the CW identifier. Up to six characters may be stored.See page 45 for details.Menu #9 [DIMMER]Function: Setting of the Display brightness level.Available Values: DIM 1/DIM 2/DIM 3/OFFDefault: DIM 1Menu #10 [DCS.COD]Function: Setting the DCS code.Available Values: 104 Standard DCS codes.Default: 023Menu #11 [DCS.N/R]Function: Selects “Normal” or “inverted” DCScoding.Available Values: TRX N/RX R/TX R/TRX RDefault: TRX NMenu #12 [DSP.SUB]Function: Selects the Sub Band display format.Available Values: FREQ/CWID/DC-IN/OFFDefault: FREQFREQ: Displays the “Sub” band frequency (Dual band operation).CWID: Displays the CW ID.DC-IN: Displays the DC supply voltage.OFF: No Display.Note: When this Menu Item is set to any selection other than the “FREQ” the “Sub” bandreceiver will be disabled.Menu #13 [DTMF D]Function: Setting of the DTMF Autodialer Delay Time.Available Values: 50MS/250MS/450MS/750MS/1000MSDefault: 450MSMENU (“SET”) M ODEDCS CODE023 025 026 031 032 036 043 047 051 053054 065 071 072 073 074 114 115 116 122125 131 132 134 143 145 152 155 156 162165 172 174 205 212 223 225 226 243 244245 246 251 252 255 261 263 265 266 271274 306 311 315 325 331 332 343 346 351356 364 365 371 411 412 413 423 431 432445 446 452 454 455 462 464 465 466 503506 516 523 526 532 546 565 606 612 624627 631 632 654 662 664 703 712 723 731732 734 743 754 – – – – – –