Yaesu FTDX9000 - UPDATE V0518 AND V11.53 Update Manual

Also see for FTDX-9000D: Operation manual Brochure & specs Update guide Update guide Update guide

(11) Press and hold in the [FAST] and [LOCK] keys while turning the radio back on. This resets theradio and locks in the new software. Turn the radio off. The updating process is now complete.Follow the instructions below to update the EDSP.EDSPThis procedure is used for uploading new EDSP Software into the FTdx9000 Amateur Transceivers,from your personal computer, using the RS-232C, DB9F to DB9F straight cable.1. Turn off the main power switch located on the back of the FTdx9000 (or turn off the powersupply for FTdx9000MP and wait a minute, until the capacitors discharge) and remove the ACpower cord.2. Connect a serial RS-232C, DB9F to DB9F straight cable to the COM1 connector of yourcomputer and the 9-pin CAT connector on the rear of the transceiver. If you use a USB to serialadapter, you might need to change the COM-Port number.3. Reconnect the power cable and turn ON the main power switch located on the back of theFTdx9000 (or turn ON the power supply for FTdx9000MP).CATMain Power SW8-pin mini-DIN PGM-SW1. Turn the main REAR power switch OFF.2. Connect a RS-232C straight cable to the CAT connector.3. Open the file FSW004.4. Insert the 8-pin mini-DIN PMG-SW connector to FTdx9000 (ACC) jack.5. Turn on the REAR Main power switch.6. I choose the .sfl file of the version V0518 to write in and push WRITE of the screen.7. When complete appears, click OK. Turn the REAR power switch OFF.8. Remove the 8-pin mini-DIN PMG-SW and the RS-232C cable.9. Turn on REAR power switch.10. Reset the radio to default.NOTE: for a more detailed description see the Main CPU programming.

/ 6

Related manuals for Yaesu FTDX-9000D