PROGRAMMING YAESU FTH-2006Programming this rig needs only a small screwdriver and some skill, no computer orinterface cords are needed.Normally this rig display only a channel number "CH 0" to "CH 9" if all memorieswhere programmed.You can't modify the frequency with the 4 keyboard's keys. But there are some (4)hidden keys somewhere to achieve this.A) Right of the display, remove the keyboard plastic cover with a small screwdriver ora knife (it's glued) and you will see 4 additional keys on the keyboard just under theoriginals.B) Those keys are like this:1) Power on the rig2) Change display from channel to frequency by pressing once the "hidden""Channel/Frequency" key.3) Adjust to the desired frequency using the big upper right knob or "Scan +" or"Scan –" keys (You can obtain a 1 MHz step depressing the "Function" keybefore turning the knob or "Scan +" or "Scan –" keys.4) From the frequency display, press the "Function" key (a small F is displayed)and quickly press the "Channel/Frequency" key, a small blinking memorynumber will appear in the upper left corner of the display, change the memorynumber using the big upper right knob or "Scan +" or "Scan –" keys and pressagain the "Channel/Frequency" key to store the memory.5) Back to "channel display" mode using the "Channel/Frequency" key, thedesired frequency is stored in the chosen memory.