22Installation and ConnectionConnecting the transceiverConnecting the front panel to the main bodyCautionMake sure to turn the transceiver OFF before connecting.1 Connect the supplied control cable to thetransceiver main body.Push the control cable plug into the CONTROLjack on the front panel of the transceiver mainbody, until it clicks.MainbodyControlcable2 Connect the other side of the front panel to thecontrol unit.Push the other control cable plug into theCONTROL jack on the transceiver control frontpanel, until it clicks. Control cableFront panelConnecting the microphone1 Connect the supplied microphone to the mainbody.Plug the microphone connector into the MIC jackon the front panel until it clicks.Tips • When disconnecting the microphone, pull the cablewhile pressing the connector latch.• Use the optional microphone extension kit “MEK-2”. An extension cable (Approx. 3 m) is suppliedwith MEK-2 allowing you to operate further awayfrom the main body.Connecting the antenna1 Connect the coaxial cable to the main body.Plug the coaxial cable jack into the ANT terminalon the rear panel of the main body, then rotateand tighten it.LOCKP3P2P171482059BACD36P4LAMPDTMF MICROPHONEMH-48ABCJKLTUVGHIPQRSDEFMNOWXYZMICConnectorMicrophoneCoaxial cable jackMain body(rear panel)
