Yaesu VX-150 Quick Programming Manual

Also see for VX-150: Specifications Specifications Operating manual

Yaesu VX-150 Quick Programming Manual Manual pdf 1 page image

Yaesu VX-150Quick ProgrammingTurn Radio on using right hand knob.Press the VFO key to select the VFO mode.Key in the frequency. The one is a given, so you start with the 10 mHz digit.IE for 146.940 you would just enter 46940.The radio has an automatic repeater offset function, so the necessary offset,plus or minus will display. If this needs to be changed, such as to go to asimplex frequency, push the “F” key followed immediately by the 0/SETkey. Rotate the main dial to item #3 (RPT). Press the “F” key, then rotate themain dial to your selection. Press the PTT button to save the setting.To set a PL tone if necessary:Press the “F” key followed immediately by the 1/SQ TYP key. Rotate thedial until TN ENC appears. Press the “F” key. To set the tone frequency,press the “F” key followed immediately by the 2/CODE key. Rotate themain dial to select the desired tone frequency. Press the “F” key to save thesettings and exit.To store the information in a memory channel, go through the steps to selecta frequency and all its associated settings. Press and HOLD the “F” key for 1second. Within 5 seconds of releasing the “F” key, rotate the dial to select amemory channel number. Press the “F” key to store the frequency inmemory.To enter the memory mode, Push the MR/SKIP key. Rotate the dial to selectthe desired memory channel.To SCAN memory channels, once in the MR mode, simply hold the/MhzA or the /MHzB key for ½ second. To stop scanning, push thePTT button. To SKIP a memory channel while scanning, select the memorychannel to be skipped, press the “F”: key momentarily, immediatelyfollowed by the MR/SKIP key. SKIP will appear in the display. To removethe SKIP, repeat the procedure.

/ 1

Related manuals for Yaesu VX-150