– 58 –• The switch installed to the STD machine may be used as is. (See diagram 3.)• The shifter switch function can be used by combining the harness and kit ECU.To use the STD switch (left side) to function as the shifter switch, connect the wire sub-lead that was packaged with this set to the terminal that is normally connected to the leftside horn. (See diagram 4.) However, if the resistor assembly is not installed, there is thepossibility that the shifter switch will operate incorrectly in rainy weather. (See diagram5.)NOTICEDo not bend the resistor assembly. It will cease to function if it is bent.Install the switch to the 2-pin black coupler underneath the fuel tank. Turning the switchON cuts the ignition.(Digram 3)StarterswitchPit road limiterON ONPUSH=OFFNot usedON OFFPit road limiterShifter switchEngine stopswitchMap selectLo → Map 1Hi → Map 2Main switch12(Diagram 4) (Diagram 5) 5
