17Installation ExamplesSuspended Installation Using Eye Bolts Suspension angleMake sure to use eye bolts within a range of 0 to 45 degrees from a right angle. Suspended installation exampleCAUTION• Before doing any installation or construction work, consult with your Yamaha dealer.• The installation should be checked thoroughly at regular intervals. Some fittings may deteriorate over extended periods oftime due to wear and/or corrosion.• When choosing the installation location, suspension wire and mounting hardware, make sure all are strong enough tosupport the weight of the speaker.• Make sure to take precautionary measures using wires to prevent the speaker from falling down in the event of an installa-tion failure.• When installing the wire to the wall, install it higher than the wire’s attachment point on the speaker, with as little slack aspossible. If the wire is too long, and the speaker happens to fall, the wire may snap as a result of too much strain.• Make sure to use eye bolts according to the standards and safety regulations in your area.Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure orimproper installation.Full rangeAttach commercially available long eye bolts (30–50 mm inlength) to the screw holes for the eye bolts (e on page 7). Thescrew diameter for DZR315(-D), DZR15(-D), and DZR12(-D) isM10, and the screw diameters for DZR10(-D) are M10 and M8.Keep in mind that you will need two or more rigging points. Securing the eye boltsInsert the eye bolts through the washers when attachingthem.• The screw holes for eye bolts go through the cabinet wall.• When using eye bolts, remove the flat-head screws tightened atthe time of factory shipment. When not using eye bolts, tightenthe flat-head screws in order to prevent air leaks.NOTEApply thread-locking fluidto the eye boltBottom0°45°Max. 45°M10 eye boltPullback pointSide RearMax. 45°