Basic components17NOTE:For instructions on using the power trim andtilt switch, see page 37.EMU26161Power trim and tilt switches (twinbinnacle type)The power trim and tilt system adjusts the out-board motor angle in relation to the transom.Pushing the switch “ ” (up) trims the out-board motor up, then tilts it up. Pressing theswitch “ ” (down) tilts the outboard motordown and trims it down. When the switch is re-leased, the outboard motor will stop in its cur-rent position.NOTE: On the dual engine control, the switch onthe remote control grip controls both out-board motors at the same time. For instructions on using the power trim andtilt switches, see pages 35 and 37.EMU26241Trim tab with anodeThe trim tab should be adjusted so that thesteering control can be turned to either theright or left by applying the same amount offorce.WARNINGEWM00840An improperly adjusted trim tab couldcause difficult steering. Always test run af-ter the trim tab has been installed or re-placed to be sure steering is correct. Besure you have tightened the bolt after ad-justing the trim tab.If the boat tends to veer the left (port side),turn the trim tab rear end to the port side “A” inthe figure. If the boat tends to veer the right(starboard side), turn the trim tab end to thestarboard side “B” in the figure.CAUTION:ECM00840The trim tab also serves as an anode toprotect the engine from electrochemicalcorrosion. Never paint the trim tab as it willbecome ineffective as an anode.1. Power trim and tilt switchZMU04601DNUP11. Trim tab2. Bolt3. Cap
