8-15ESU00171Checking the oil level of the drive chain housingWARNING@The engine and muffler will be very hot after theengine has been run. Avoid touching the engine andmuffler while they are still hot with any part of yourbody or clothing during inspection or repair.@1. Place the snowmobile on a level surface.2. Remove the dipstick 1 and wipe it off with a cleanrag. Then put the dipstick in the hole.CAUTION:@There is a magnet attached to the end of the dipstick.It is used to remove any metal particles that mayaccumulate in the drive chain housing. When remov-ing the dipstick be sure to: Pull it out slowly and gently so the metal particlesdo not fall off the magnet back into the drivechain housing. Wipe off the magnet before reinserting the dip-stick into the drive chain housing.@3. Pull up the dipstick and check that the oil is betweenthe upper and lower levels. If not, add oil to the upperlevel.2 Upper level3 Lower levelÈ For models without reverse transmissions(MM600 / SX600)É For models with reverse transmissions(VT600 / VX600ER)CAUTION:@Make sure that no foreign material enters the drivechain housing.@A BDrive chain oil: API GL-3SAE 75 or 80