Yamaha MusicCast SUB 100 Owner's Manual

Also see for MusicCast SUB 100: Setup guide Owner's manual

Contents

10 En1 A (STANDBY/ON)This switches the unit’s power between on andstandby.2 Service portThis is for service, and is not normally used.3 CONNECTThis is used for the following operations.4 WIRELESS switchThis turns the wireless communication functionality(wireless LAN) on/off.AUTO:Wireless communication is on.OFF:Wireless communication is off. If connecting the unitto a network, use a wired connection. (→ p. 14 “Ifconnecting via a cable”)5 INPUT switchThis switches the unit’s type of connection.NET:Choose this if you’re connecting the unit to a network.ANALOG:Choose this if you’re connecting the unit directly to anamp or similar device, without connecting to anetwork.6 INPUT (ANALOG) jackUse this if the INPUT switch is set to ANALOG.Connect a cable from the amp’s subwoofer jack or lineoutput jack (such as PRE OUT) to this jack.(→ p. 14 “If connecting via a cable”)7 Service portsThese are for service, and are not normally used.8 NETWORK portUse a network cable (commercially available) toconnect to your network via a cabled connection.PARTS AND THEIR FUNCTIONSRear panel1 32 4 5 86 7● Registering this unit on theMusicCast network → p. 15● Updating the firmware → p. 18● Initializing the settings(factory reset) → p. 19