Yamaha NS-9900 Owner's Manual

Contents

2 EnWhen placing the speakers, be sure to use the stands toincrease stability.• The provided stands are in two types. Two stands arefor the right side and others are for the left side. Attacheach stand to the proper position on the bottom of thespeaker by following the figure below.• When attaching the stands to the speaker, have anotherperson support it.• To attach the stands to the speaker, be sure to lay downthe speaker while the front is facing up. We recommendusing a blanket or cushion (thickness of 3 cm or more)to raise the speaker from the floor.Use the 8 specified holes located on the base of the speaker.How to attach1 Put a screw through a washer, then through theinner hole of the stand, and screw it into the outsidehole of the speaker. Do not tighten too much at thispoint.2 Put a screw through a washer, then through theouter hole of the stand, and screw it into the otherhole on the base of the speaker.3 Tighten both of the screws firmly.4 Attach a pad to the bottom of the end portion of thestand.5 Attach the other stands to the other corners of thebase of the speaker in the same way and confirmthat all 4 stands have been firmly attached.Be careful not to apply force to the side of the speaker,otherwise the speaker may fall causing damage to thespeaker or personal injury.SUPPLIED ACCESSORIESRLSpeaker cable(4 m) x 1 Stand(R x 2, L x 2) Screw(M4, 25 mm)x 8Non-skid pad(1 set: 4 pcs) Washer x 8ATTACHING THE STANDSNotes(L) (R)(R) (L)FrontBackView from the bottom of the speakerNoteROuter holeInner hole