BEFORE MAKING CONNECTIONS, MAKE SURE THATTHE AMPLIFIER IS SWITCHED OFF.n CONNECTIONS● Connect the screw-type input terminals at the rear of thespeaker to the speaker output terminals of your amplifierwith the provided speaker cords.● One side of the speaker cord is red and the other side isblack. Connect the (+) terminals on both the amplifierand the speaker using this red side. Connect the (–) ter-minals on both components using the black side of thecord.● Be careful not to reverse the polarity (+, –). If connectedwith reversed polarity, the sound will be unnatural andlack bass.Procedures:À Loosen the terminal knob.Á Insert the bare speaker wire end properly into the ter-minal hole. [Remove approx. 10 mm (3/8”) insulationfrom the speaker cord.]Â Tighten the knob.Ã Test the security of the connection by pulling lightly thecord at the terminal.NoteDo not let the bare speaker wires touch each other asthis could damage the speaker orthe amplifier, or both of them.SPECIFICATIONSType..........................2-way 3-speaker acoustic-suspensionspeaker systemMagnetic-shielding typeSpeaker Unit ....................................10 cm cone woofer x 22.2 cm dome tweeterInput Terminal .....................................................Screw-typeImpedance .................................................................6 ohmFrequency Response ..................................70 Hz – 30 kHzNominal Input Power.....................................................60WMaximum Input Power ................................................180WSensitivity (2.83V, 1m) ................................................91 dBCrossover Frequency ..................................................5 kHzDimensions (WxHxD).......................465 x 135 x 173.5 mm(18-5/16” x 5-5/16” x 6-7/8”)Weight .................................................3.5 kg (7 lbs. 12 oz.)Accessories ......................................Speaker cord (4m) x 1Velcro strip x 2* Specifications subject to change without notice due toproduct improvements.* Care should be taken not to exceed the input power val-ues noted above.CONNECTION TO YOUR AMPLIFIERCenter speakeroutput terminalsof the amplifierNS-C55TightenRed (+)Black (–)RedLoosenAmplifierV415010