Yamaha NS-P80 Owner's Manual

Contents

English3EnFasten screws into a firm wall or wall support as shown inthe figure below, and hang the holes on the protrudingscrews.WARNING● Each speaker weights 2.3 kg (5 lbs. 2 oz.). Do notmount them on thin plywood or soft wall surfacematerial, as the screws may come out of the flimsysurface, causing the speakers to fall down and bedamaged, or result in personal injury.● Do not fasten the speakers to wall with nails,adhesives, or other unsound hardware. Long termuse and vibrations may cause them to fall down.● To avoid accidents resulting from tripping overloose speaker cords, fix them to the wall.The speakers can be mounted on a wall by using thebracket attached to the back panel of each speaker.Make sure that the screws are caught by a narrow part ofthe holes securely.Put the screws into a wall according to the figure shownbelow. Mounting the surround and surround back speakers on the wallHolesPads40 mm3 mm3.5 to 4 mm tapping screw(available at a hardware store)Wall orwallsupportPlace the speaker on the TV whose top is flat or on the floorunder the TV or inside the TV rack so that it is stabilized.When placing the speaker on top of the TV, to prevent thespeaker from falling down, put the provided fasteners at twopoints on both bottom of the speaker and top of the TV. Placing the center speakerFastenerTV setNotes● Do not place the speaker on top of the TV whosearea is smaller than the bottom area of the speaker.If placed, the speaker may drop out causing aninjury to you.● Do not place the speaker on top of the TV with aninclination.● Do not touch the adhesive surface after peeling offthe seal as this will weaken its adhesive strength.● Thoroughly wipe clean the surface where thefastener is to be applied. Note that adhesivestrength is weakened if the surface is dirty, oily orwet and that this may cause the center speaker todrop.ScreenPeel offthe seal.Min. 20 mm