6-4CAUTION:@ When adding the engine oil, be careful not to fillabove the “F” level mark on the oil levelgauge/dipstick. Make sure that no foreign material enters theengine oil tank.@7. Insert the oil level gauge/dipstick into the oil fillerhole, and then tighten it securely.8. Connect the oil level gauge coupler.9. Install the right side cover and the shroud.ESU04511CoolantChecking the coolant level1. Remove the top cover. (See pages 8-5–8-7 forremoval procedures.)2. Check the coolant level in the coolant recovery tankwhen the engine is cold. If the coolant level is belowthe “COLD LEVEL” mark, add soft water until itreaches the “COLD LEVEL” mark. (See pages 8-14–8-16 for more details.)1 “COLD LEVEL” markWARNING@Do not remove the coolant reservoir cap when theengine is hot.@2 Coolant reservoir capCAUTION:@ Hard water or salt water is harmful to the engineparts. You may use boiled or distilled water, if softwater is not available. Tap water can be used temporarily in an emer-gency.@
