Yamaha Revolabs Executive Elite 01-ELITEEXEC8 Room Control Api Manual

Also see for Revolabs Executive Elite 01-ELITEEXEC4: Installation and operation guide

Contents

5connection. Client mode in the executive Elite is persistent, meaning that if the servergoes down or the connection is lost for any reason, the Executive Elite will periodicallyping the server until the connection is re-established, without requiring a reboot.If the Executive Elite is the server, only one device can login at a time. The loginusername is revolabs and the password is elite, both case sensitive. The portnumber is the standard Telnet port 23.The Executive Elite can be configured for external mute on the External ControlConfiguration page of the local web UI. When external mute is set to On, theExecutive Elite base DSP will always pass audio, even when the microphones aremuted. In this case it is the responsibility of the installer to ensure that mute isperformed in the external component of the installation.Instead of a Room Control System, the Executive Elite system can receive commandsalso from a DSP system. In this case select the DSP from the list in the Processordrop-down menu.NOTE: Both a control system and DSP cannot be connected to a Base Station asa serial control processor at the same time. When using a control systemand DSP at the same time, DSP control is typically done from the roomcontrol system, with the Executive Elite either connected to the DSP orthe Room Control System.Serial Command & Return StringsThe Serial Strings of an Executive Elite Base Station begin with the Argument andterminates with a Carriage Return. The Command String structure is as follows:[] [ch Number> ] The argument is either ‘set’ or ‘get’. While it is used on most commands, there aresome command snot using the set and get argument. They are liste din the tablebelow.If specific microphone channels are affected by the command, the string ‘ch’ isfollowed by the microphone channel number, and the value which is sent (‘set’command).All variable changes on any microphone or the Executive Elite Base Station will resultin a Return String. A Return String will begin with “val” and terminate with a CarriageReturn. Return Strings will be received for every value change that has taken place inthe microphones or base station including changes that are a result of a CommandString sent to the Executive Elite Base Station, but also for changes initiated from themicrophone or the web interface or front panel interface. The Return String structureis as follows:val ch Number>