PERIODIC MAINTENANCE AND ADJUSTMENT7-2574. Disconnect the battery coupler.5. Remove the blown fuse, and theninstall a new fuse of the specifiedamperage. WARNING! Do notuse a fuse of a higher amperagerating than recommended toavoid causing extensive dam-age to the electrical system andpossibly a fire. [EWA15131]6. Connect the battery coupler.7. Install the battery cover by install-ing the bolts.8. Install the seat.9. Turn the key to “ON”.10. If the fuse immediately blowsagain, have a Yamaha dealercheck the electrical system.EAU24350Supporting the motorcycleSince this model is not equipped with acenterstand, follow these precautionswhen removing the front and rearwheel or performing other maintenancerequiring the motorcycle to stand up-right. Check that the motorcycle is in astable and level position before startingany maintenance. A strong woodenbox can be placed under the engine foradded stability.To service the front wheel1. Stabilize the rear of the motorcycleby using a motorcycle stand or, ifan additional motorcycle stand isnot available, by placing a jack un-der the frame in front of the rearwheel.2. Raise the front wheel off theground by using a motorcyclestand.To service the rear wheelRaise the rear wheel off the ground byusing a motorcycle stand or, if a motor-cycle stand is not available, by placing1. Bolt2. Battery3. Battery cover1. Battery coupler1Specified fuse:10.0 AU2CJ80E0.book Page 25 Tuesday, June 12, 2012 11:15 AM