Yamaha WR250F Owner's Service Manual

Also see for wr250f: Owner's service manual Owner's service manual Owner's service manual Owner's service manual Owner's service manual

Contents

6-30STEERING7. Install:• Front fork "1"• Upper bracket "2"• Main switch "3"• Front brake hose guide bracket"4"• Temporarily tighten the pinch bolts(lowerbracket).• Do not tighten the pinch bolts (up-per bracket)yet.8. Install:• Guide (speed sensor lead) "1"After installing the guide as shown,pass the speed sensor lead throughthe guide.9. Install:• Washer "1"• Steering stem nut "2"10. After tightening the nut, check thesteering for smooth movement. Ifnot, adjust the steering by loosen-ing the steering ring nut little by lit-tle.11. Adjust:• Front fork top end "a"12. Tighten:• Pinch bolt (upper bracket) "1"• Pinch bolt (lower bracket) "2"Tighten the lower bracket to speci-fied torque. If torqued too much, itmay cause the front fork to mal-function.13. Install:• Multi-function display bracket "1"• Multi-function display "2"Pass the throttle cables "3", clutch ca-ble "4" and hot starter cable "5" be-tween the multi-function displaybracket and upper bracket.14. Install:• Holder "1"• Clamp "2"• Install so that the marking "a" on thespeed sensor lead aligns with theholder edge.• Fasten the speed sensor lead to theholder with the clamp.Steering stem nut:145 Nm (14.5 m•kg, 105ft•lb)Front fork top end (stan-dard) "a":5 mm (0.20 in)Pinch bolt (upper brack-et):21 Nm (2.1 m•kg, 15ft•lb)Pinch bolt (lower brack-et):21 Nm (2.1 m•kg, 15ft•lb)Multi-function displaybracket:7 Nm (0.7 m•kg, 5.1ft•lb)Multi-function display:4 Nm (0.4 m•kg, 2.9ft•lb)Holder:13 Nm (1.3 m•kg, 9.4ft•lb)Clamp:7 Nm (0.7 m•kg, 5.1ft•lb)