8-17814. Remove the engine oil tank filler cap, and thengradually fill the oil tank with the remaining oilquantity while regularly checking the oil levelon the dipstick.15. Install and tighten the engine oil tank filler cap.TIPBe sure to wipe off spilled oil on any parts after theengine and exhaust system have cooled down.NOTICEECB00300● In order to prevent clutch slippage (since theengine oil also lubricates the clutch), do notmix any chemical additives. Do not use oilswith a diesel specification of “CD” or oils ofa higher quality than specified. In addition,do not use oils labeled “ENERGY CONSERV-ING II” or higher.● Make sure that no foreign material enters thecrankcase.16. Start the engine, and then let it idle for severalminutes while checking it for oil leakage. If oilis leaking, immediately turn the engine off andcheck for the cause.17. Turn the engine off, and then check the oil lev-el and correct it if necessary.EBU23470CoolantThe coolant level should be checked before eachride. In addition, the coolant must be changed atthe intervals specified in the periodic maintenanceand lubrication chart.EBU27942To check the coolant level1. Place the ATV on a level surface.Recommended oil:See page 10-1.Oil quantity:Without oil filter element replacement:1.75 L (1.85 US qt, 1.54 Imp.qt)With oil filter element replacement:1.85 L (1.96 US qt, 1.63 Imp.qt)
