Yamaha YST-SW005 Owner's Manual

Also see for YST-SW005: Owner's manual Service manual Service manual

Contents

EnglishE-7INPUT1FROM AMPLIFIEROUTPUTTO SPEAKERSINPUT2 /MONOAUTOSTANDBYOFFLOWHIGH LOWHIGH HIGH CUTOFFPOWERONVOLUME0 10INPUT1FROM AMPLIFIEROUTPUTTO SPEAKERSINPUT2 /MONOAUTOSTANDBYOFFLOWHIGH LOWHIGH HIGH CUTOFFPOWERONVOLUME0 10INPUT1FROM AMPLIFIEROUTPUTTO SPEAKERSINPUT1FROM AMPLIFIEROUTPUTTO SPEAKERSFor connections, keep the speaker cables as short aspossible. Do not bundle or roll up the excess part of thecables. If the connections are faulty, no sound will be heardfrom the subwoofer or the speakers, or both of them. Makesure that the + and – polarity markings of the speakercables are observed and set correctly. If these cables arereversed, the sound will be unnatural and lack bass.How to Connect:Red: positive (+)Black: negative (–)CautionDo not let the bare speaker wires touch each other asthis could damage the subwoofer or the amplifier, orboth of them.1 Press and hold the terminal’s tab, as shown in the figure.2 Insert the bare wire end properly into the terminal hole.[Remove approx. 10 mm (3/8”) insulation from thespeaker cable.]3 Release your finger from the tab to allow it to locksecurely on the cable’s wire end.4 Test the firmness of the connection by pulling lightly onthe cable at the terminal. Using two subwoofersConnect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUTterminals of the subwoofer to the main speakers.Left mainspeakerRight mainspeakerRight subwooferSpeaker outputterminalsTo AC outletConnecting to the INPUT1/OUTPUT terminals of the subwooferLeft subwooferTo AC outletAmplifier➂➀ ➁