NOTE:_If the engine fails to start, release the key, andthen try starting again. Wait a few secondsbefore the next attempt. Each cranking shouldbe as short as possible to preserve batteryenergy. Do not crank the engine more than5 seconds on each attempt._5. If the engine is started with the starter(choke) in position 1, the starter (choke)should be returned to position 2 to warmup the engine. If the engine is started withthe starter (choke) in position 2, keepthe starter (choke) in this position towarm up the engine.6. Continue warming up the engine until itidles smoothly and return the starter(choke) to position 3 before riding.EBU01800Starting a warm engineTo start a warm engine, refer to the “Starting acold engine” section. The starter (choke)should not be used. Press the acceleratorpedal slightly.EBU90028Jump-startingJump-starting the vehicle should be avoided.The battery should be removed and chargedinstead. (See pages 8-41–8-42 for battery re-moval and installation procedures.) However,if the vehicle must be jump-started, proceedas follows.1. Turn the key to “OFF”.2. Open the hood. (See page 8-6 for hoodopening and closing procedures.)3. Remove the battery case cover.U5UG10.book Page 3 Friday, August 1, 2003 7:40 PM