Yard-Man 12A-559K401 Operator's Manual

Also see for Yard-Man 12A-559K401: Operator's manual Operator's manual

Contents

Yard-Man 12A-559K401 Operator's Manual Manual pdf 7 page image

7SECTION 3: HARDWARE PACKPlease identify each piece of the hardware pack asshown in Figure 1.Figure 1SECTION 4: UNPACKINGRemoving Unit From Carton• Remove staples, break glue on top flaps, or cuttape at carton end and peel along top flap to opencarton.• Remove loose parts included with unit (i.e.,operator’s manual, oil, etc.).• Cut corners and lay carton down flat. Removepacking material.• Roll or slide unit out of carton. Check cartonthoroughly for loose parts.NOTE: Make sure not to crimp the cables whileremoving the loose parts or the entire unit from thecarton.NOTE: Reference to right or left hand side of the mowerand/or front or behind the mower is observed from theoperating position.SECTION 5: ASSEMBLING YOUR LAWN MOWERTools Required• Pair of Pliers• Funnel• Set of adjustable wrenchesDisconnecting Spark Plug• Before setting up your lawn mower, disconnect thespark plug wire from the spark plug, and ground itagainst the engine. See Figure 2.• Attach the spark plug wire to a bolt on the engine toground it.Figure 2Assembling Handle• Remove grass bag from the unit and set it out of theway. See Figure 3 (step 1).• Remove any packing material which may bebetween the upper and lower handles for shippingpurposes.Figure 3• Raise the lower handle in the direction shown inFigure 3 (step 2) till it snaps into place.Wing Nut 1/4-20 (2) Carriage Bolt 1/4-20 (2)Spark PlugWireSpark Plug1. Move bag2. Lift lower handle3. Lift upperhandleaway