Yongnuo YN-622C User Manual

Also see for TOYUG YN-622C: User manual User guide User guide Quick start guide

Contents

Yongnuo YN-622C User Manual Manual pdf 15 page image

The Other YN-622C User Guide28/08/2013 Page 15 of 23Flash Exposure Lock (FEL)Press the camera’s [FEL] or [*] button to start an FEL action.• The camera must be in a creative mode.• Live View mode must be disabled.• Flash mode must be E-TTL.• Flash metering temporarily changes to Spot metering. The ambient and flash exposuresare locked into the camera for 16 seconds, or while [½-shutter] remains pressed. Thevalues are discarded when the shot is taken, or a hi-speed burst ends.• If the subject is too far away and underexposure will result, the < Flash > icon will blink inthe viewfinder. Move closer to the subject and try the FE lock again.Flash Exposure Bracketing (FEB)• Set FEB in 1/3-stop increments within 2 or 3.• The zero point for FEB is adjusted by the global FEC setting.• The sequence of FEB is fixed at 0 - +, even when the on-flash setting is different.• The FEB function will be automatically cancelled after three shots are taken.• An E-TTL flash which does not support FEB can also be used.MANUAL MODERemote Manual LevelsType A camera menus can remotely control Mk II Speedlites and YN flashes.• All (global), groups A and B, or A, B and C.• Power levels 1/1 to 1/128, by Group• E-TTL Flashes do not emit a pre-flashAll Flashes (Global setting)• Set Flash Mode to Manual.• Set Flash Output as required, 1/128 to 1/1 power level, in 1/3-stop increments.• Either, Set Wireless function to Disable, or Enable with Firing Group A+B+C.Two and three lighting groups• Set Flash Mode to Manual.• Ignore Flash Output: it will repeat group A setting.• Set Wireless function to Enable.• Set Firing Group to A:B (C will not fire) or A:B C.• Set each Group Output as required, 1/128 to 1/1 power level, in 1/3-stop increments.• On-top flash will fire at group A level, if Master Flash is enabled.On-Flash Manual LevelsType A, B or C cameras can trigger flashes where the output level has been set on-flash.• Flash connected by PC-sync cable.• Power levels set on individual flash.• E-TTL Flashes do not emit a pre-flash