York CU060 Installation Instruction

Contents

York CU060 Installation Instruction Manual pdf 4 page image

036-33072-001 Rev. A (0601)4 Unitary Products GroupFIGURE 1: TYPICAL INSTALLATION LAYOUT (CU180 SHOWN)INSTALLATIONPRE-INSTALLATION INSPECTION OF EQUIPMENTAll units are factory tested to ensure safe operation and qual-ity assembly. Units are packaged and sealed on shippingskids and shipped in first class condition. Torn and brokenpackaging, scratched or dented panels should be reported tocarrier immediately. Internal inspection of all units should beperformed prior to installation. Remove all access doors andcheck for visual defects that can occur during transport. Anyproblems found internally should be reported to carrier andmanufacturer immediately. Refrigerant circuit should bechecked to ensure no leaks have occurred during shipment.Install gauge set to high and low pressure ports to confirmpressure has been maintained and no leaks have occurredduring shipment. Repair any damage prior to installation toensure safe operation.NOTE: Record any unit damage on the Bill of Lading andreport to carrier and factory immediately. Shipping and han-dling damages are not warranty items.RIGGINGUnits are not built to accommodate rigging of chains for lift-ing. Please use straps to insure proper lift. See WARNINGS:SITE LOCATIONPRIOR TO MOUNTING UNIT, CHECK INDIVID-UAL UNIT WEIGHTS AND VERIFY LIFTINGCAPACITY OF LIFTING EQUIPMENT EXCEEDSWEIGHT OF UNITS BY SAFE MARGINS. FAIL-URE TO DO SO MAY RESULT IN UNIT DAM-AGE, PERSONAL INJURY OR EVEN DEATH.DETERMINE THE ACTUAL CENTER OF GRAV-ITY OF THE UNIT BY PERFORMING A TESTLIFT. LIFTING AN UNBALANCED UNIT CANCAUSE PERSONAL INJURY OR EVEN DEATH.WARNINGWARNING