York SUNLINE 2000 Installation Manual

Also see for Sunline 2000: Installation instruction Installation instructions Installation instructions Technical guide Technical guide

York SUNLINE 2000 Installation Manual Manual pdf 9 page image

175245-YIM-C-1008Johnson Controls Unitary Products 9COMPRESSORSUnits are shipped with compressor mountings factory-adjusted and ready for operation.FILTERSTwo-inch or four-inch filters can be supplied with eachunit. Filters must always be installed ahead of theevaporator coil and must be kept clean or replaced withsame size and type. Dirty filters will reduce the capacityof the unit and will result in frosted coils or safety shut-down. Minimum filter area and required sizes areshown in Physical Data Table 5.SERVICE ACCESSThe following removable panels provide access to allserviceable components:• Compressor compartment• Electric Heat compartment• Side Supply & Return Air compartments(Two panels)• Blower compartment (Three panels)• Main control box• Filter compartment• Outdoor Air compartment (Two panels)Refer to the Unit Dimensions Figures 10 and 11 forlocation of these access panels.FIGURE 4 - RECOMMENDED DRAIN PIPINGDo not loosen compressor mounting bolts.Make sure that all screws and panel latchesare replaced and properly positioned on theunit to maintain an airtight seal.