5532522-UIM-B-06198 Johnson Controls Ducted SystemsThe furnace must be isolated from the gas supply piping system byclosing its individual external manual shutoff valve during any pressuretesting of the gas supply piping system at pressures equal to or lessthan 1/2 psig (3.5 kPa).Gas piping may be connected from either side of the furnace usingeither of the gas pipe entry locations shown in Figures 6 & 9.HIGH ALTITUDEThis furnace is constructed at the factory for natural gas-fired operationat 0 – 5,000 feet (0 – 1,524 m) above sea level.SECTION V: ELECTRICAL POWERELECTRICAL POWER CONNECTIONSField wiring to the unit must be grounded. Electric wires that are fieldinstalled shall conform to the temperature limitation for 63ºF (35ºC) risewire when installed in accordance with instructions. Refer to Table 4 inthese instructions for specific furnace electrical data.The residential supply must have a bonded neutral.Annual Fuel Utilization Efficiency (AFUE) numbers are determined in accordance with DOE Test procedures.Wire size and over current protection must comply with the National Electrical Code (NFPA-70-latest edition) and all local codes.The furnace shall be installed so that the electrical components are protected from water.FIGURE 9: Gas PipingGROUNDUNIONDRIPLEGMANUALSHUT-OFFVALVEGROUNDUNIONDRIPLEGUPFLOWDRIPLEGDRIPLEGGROUNDUNIONMANUALSHUT-OFFVALVEGROUNDUNIONIMPORTANT: An accessible manual shutoff valve must be installedupstream of the furnace gas controls and within 6 feet (1.8 m) of thefurnace.CAUTIONThe gas valve body is a very thin casting that cannot take any exter-nal pressure. Never apply a pipe wrench to the body of the gas valvewhen installing piping. A wrench must be placed on the octagon hublocated on the gas inlet side of the valve. Placing a wrench to thebody of the gas valve will damage the valve causing improper opera-tion and/or the valve to leak.!CAUTIONUse copper conductors only.!Table 4: Ratings & Physical / Electrical DataInput Output NominalAirflow AFUEAir Temp.RiseMax.OutletAir TempBlower BlowerSizeRecommendedFuse or CircuitBreaker AmpsTotalUnitAmpsGas PipeConnection,NPTMBH kW MBH kW CFM m3 /min ºF ºC ºF ºC HP Amps60 17.6 48 14.1 1200 34.0 80.0 35-65 19-36 190 88 1/2 6.4 11 x 8 15 9.0 1/2"80 23.5 64 18.8 1600 45.3 80.0 35-65 19-36 190 88 1/2 6.4 11 x 10 15 9.0 1/2"100 29.3 80 23.4 2000 56.6 80.0 35-65 19-36 190 88 3/4 8.8 11 x 11 15 11.4 1/2"