Z Microsystems ZX3 User Manual
                      | |
Contents
| 
14Doc# 27-0044UM Rev B Issued 7/13/2012OPERATIONS4.4 INSERTING ThE TRANZPAk2 STORAGE MOdULE4.3 REMOvING ThE TRANZPAk2 STORAGE MOdULE1. Slide the locking catch towards the rightto allow the locking handle to spring open.3. Push the locking handle to the lef t.This will disconnect the TranzPak2 fromthe rear connector.4. Gently but firmly begin to pull theTranzPak2 module out as it slides off thegrounding contacts.2. The locking handle will swing out.1. Raise the TranzPak2 module to the slot.and insert into the docking bay .2. Use your thumb to gently push on theTranzPak2 thumb plate in order to slidethe module into the docking bay3. Gently push on the TranzPak2 thumbplate until the module is seated againstthe rear connector.4. Press the locking handle until it snapsinto place. |
Related manuals for Z Microsystems ZX3
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine