SAFETYZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 23ZI-HAEK4100 / ZI-HAEK1100012 SAFETY12.1 Intended UseThe machine must only be used for its intended purpose! Any other use is deemed to be a case ofmisuse.To use the machine properly you must also observe and follow all safety regulations, the assemblyinstructions, operating and maintenance instructions lay down in this manual.All people who use and service the machine have to be acquainted with this manual and must beinformed about the machine's potential hazards.It is also imperative to observe the accident prevention regulations in force in your area.The same applies for the general rules of occupational health and safety.The machine is used for:Shredding of branches of all kinds (depending on the type of wood and freshness). Wilted, moist,garden waste already stored several days alternating with tree branches.This machines with drawbar are not approved for public road traffic!Any manipulation of the machine or its parts is a misuse, in this case ZIPPER-MASCHINENand its sales partners cannot be made liable for ANY direct or indirect damage.W A R N I N G Set during the operation could ensure that no foreign objects (such as stones, glass,metal, earth, and plastic) are filled into the shredder, such as foreign bodies bluntthe chopping blade and severely damage the engine. Use your shredder solely for the purposes for which it was designed. The chopper should be carefully checked before use. Never use a chopper that is notin good condition if you notice a defect on the machine, which could pose a danger tothe user, do not use the chopper until the defects have been corrected. This machine contains rotating blades. This blades does not stop immediately after stopping. The in-feed must be completely assembled and fixed prior to use.Prohibited use: The operation of the machine outside the stated technical limits described in this manual isforbidden. Operation of the machine function without any protection devices is forbidden The use of the machine for any purposes other than described in this user-manual is forbidden. Any manipulation of the machine and parts is forbidden. The use of the machine not being suitable for the use of the machine and not being certified isforbidden. It is not allowed to leave the immediate work area during the work is being performed!