ZOLL M Series CCT Configuration Manual

Also see for M Series CCT: Manual

ZOLL M Series CCT Configuration Manual Manual pdf 28 page image

M SERIES CCT CONFIGURATION G UIDE24Highlight the Clock Synchronization option and press the Change Value softkey to display thefollowing screen:Press the Change Value softkey to scroll through the available values for each parameter.Press the Next Item softkey to move to the next parameter in the table.Press the Return softkey to save the values entered and return to the main configuration menu.You can set the values for the following Clock Synchronization options:• Time Zone: Selects the time zone in which the M Series CCT will be used.Choices include: Azores, Middle Atlantic, S. America Eastern, ASTAtlantic, EST Eastern, CST Central, MST Mountain, PST Pacific,AKST Alaska, HST Hawaiian, Samoa, Dateline, GMT Greenwich,CET Central Europe, EET Eastern Europe, MSK Moscow, Arabian,Afghanistan, West Asia, Central Asia, Southeast Asia, AWSTAustralian West, Korean, ACST Australian Cent, AEST AustralianEast, Central Pacific, or New Zealand• Dial Location: Sets the National Institute of Science and Technology (NIST) dialinglocation to either Hawaii or Colorado. This is the location called bythe M Series CCT to obtain accurate time information for setting itsinternal clock.• Prefix: Affixes up to eight user selectable digits or special characters (+, &, !,*, or comma) to the start of the dialing location phone number.Daylight SavingsWhen set to “Yes” and the user dials the selected NIST location, the unit will automaticallyadjust the time for Daylight Savings based on the assumption that DST starts on the firstSunday in April at 1:59:59 AM (setting the time ahead by one hour) and ends on the last Sundayin October at 1:59:59 AM (setting the time back by one hour).Card Capacity Message EnabledWhen set to “Yes” and data recording is enabled with a data card present, the M Series CCTwill display “CARD LOW” messages when the remaining storage capacity of the card reaches30, 15, and 5 minutes.To enable this option, the “Report Memory Card Errors” option must be set to “Yes”; otherwise,the option is ignored.Erase Card Prompt at Pwr OffSets the M Series CCT unit to allow the user to erase the data card at power-off if the cardcontains only self test, and optionally, synchronized cardioversion data. To enable this option,6\VWHP&RQILJXUDWLRQ3UHY,WHP1H[W,WHP&KDQJH9DOXH(67(DVWHUQ&RORUDGRBBBBBBBB5HWXUQ7LPH=RQH'LDO/RFDWLRQ'LDO3UHIL[&ORFN6\QFKURQL]DWLRQ