Zanussi ZCG 7551X Instruction Booklet

Zanussi ZCG 7551X Instruction Booklet Manual pdf 50 page image

10. CHECKING THE MAIN OVEN CONTROLS TO SET THE TIME OF DAY (see Fig.6)1. Turn on the electricity supply and ensure that thethermostat is in the off position.1a. Before setting timer read important note below.2. Rotate the left hand clock knob to 'Manual' and back tothe 'Clock' position.3. Set the time of day by rotating the right hand knob. Notethat it is a 24 hour clock.4. Rotate the left hand clock knob back to the 'Manual'position.NOTE: When setting the time of day with the selector knob inthe 'Clock' position only, this will activate the timer for seven seconds after selection. This means that whensetting the time of day in this function the time can only be set by using the right hand knob within a sevensecond period.After seven seconds have elapsed from when the correct time of day has been set, the timer ceasesto be active and subsequent operation of the right hand knob will not change the time setting.11. CHECKING THE MAIN OVEN1. Set the clock as described above, the clock is now ready for manual operation.2. Turn the oven thermostat knob to Mk 9 and press the ignition button. As soon as the burner is alightthe button can be released.3. There should now be a low gas rate to the burner, which is the F.S.D. by pass rate.4. When the F.S.D. phial has heated up it opens the F.S.D. valve which allows the main gas supply tothe oven burner.5. After 1 minute check that the flame covers the full width of the burner and is stable.6. Set the oven control to Mk 2, close the oven door and check that after about 10 minutes the flame sizehas reduced.7. Turn off the control and check that the oven flames go out.12. AUTOMATIC OPERATIONHaving set the clock up as described above, turn the left hand knob to the 'Cook' position and set the righthand knob to show a cooking time of two minutes (0.02).Turn the left hand knob to the 'Stop' position; the time shown on the display is now the time of day with twominutes added on. Rotate the right hand knob to add two minutes to this time to give a two minute delay.Turn the left hand knob to the 'Auto' position to complete the programming sequence, the clock now showsthe time of day again with 'Auto' glowing continuously.Turn the oven thermostat on and two minutes after setting, the oven burner should commence its lightingsequence.Two minutes after the lighting sequence has started the timer should cut off the gas supply to the ovenburner and the audible signal should sound. The signal is continuous it may be switched off at any time byrotating the left hand knob.Return timer to manual by rotating the left hand knob to the 'Manual' position.50 50Fig.6