Zanussi ZCG55 User Manual

Contents

Zanussi ZCG55 User Manual Manual pdf 9 page image

Replacing burner parts1. Carefully put the burner crown on the burn-er body. Do not use force.a) Make sure that the hole in the crown isabove the ignition candle.b) Make sure that the location pegs are inthe slots in the burner body.c) Let the crown fall freely onto the body.d) Make sure that you can move thecrown a small distance from side toside.2. Put the burner cap centrally on top of thecrown (enamel side up). Move the cap fromside to side and front to back to make surethat it is correctly installed.3. Try to light the burner. If the burner doesnot ignite, adjust the crown and cap again.Warning! Do not keep control knobpressed for more than 15 seconds.If the burner does not light after 15 seconds,release the control knob, turn it into off positionand wait for at least 1 minute before trying tolight the burner again.If the burner accidentally goes out, turn thecontrol knob to the off position and try tolight the burner again after minimum 1 minute.The spark generator can start automaticallywhen you switch on the mains, after instal-lation or a power cut. It is normal.Turning the burner offTo put the flame out, turn the knob to the sym-bol .Warning! Always turn the flame down orswitch it off before you remove the pansfrom the burner.Hob - Helpful hints and tipsWarning! Refer to the Safety chapters.Energy savings• If possible, always put the lids on the pans.• When the liquid starts to boil, turn down theflame to barely simmer the liquid.Use pots and pans with diameter applica-ble to the dimension of burner.Burner Diameters of cookwareRapid 180 mm - 260 mmSemi-rapid 120 mm - 220 mmAuxiliary 80 mm - 160 mmUse cookware with the bottom as thick and flatas possible.Hob - Care and cleaningWarning! Refer to the Safety chapters.Clean the appliance after each use.Always use cookware with clean bottom.Warning! Switch the appliance off and letit cool down before you clean it.Warning! For safety reasons, do not cleanthe appliance with steam cleaners or high-pressure cleaners.Warning! Do not use abrasive cleaners,steel wool pads or acids, they can causedamage to the appliance.• To clean the enamelled parts, cap and crown,wash it with warm soapy water.• Stainless steel parts wash with water, andthen dry with a soft cloth.• The pan supports are not dishwasher proof;they must be washed by hand.• Make sure you position the pan supports cor-rectly after cleaning.• To make burners work correctly, make surethat the arms of the pan supports are in thecentre of the burner.9www.zanussi.com