Zanussi ZCM 5262 Instruction Book

Contents

10Ignition of the burners1. Push the knob and turn it left to the “largeflame” symbol.2. At the same time, push the electronicignition knob (fig. 11) for obtaining sparkles.Keep it pushed till turning up of the flame (1spark / second).orLack of power1. Push the corresponding knob in completelyand turn it left to the “large flame” symbol andignite with a match.2. Hold a flame to the gas oven burner holes.3. The hob burners are provided with a safetydevice. The control knob must be pressedin for approximately 10 seconds until thesafety valve automatically keeps the flamelit.4. Release the knob and watch that the burnerhas ignited. Upon ignition, adjust the flame asrequired.If for any reason the flame should extinguish turnoff the relevant control know, leave for at leastone minute and then re-ignite.If after a few attempts the burner does not ignite,check that the burner ring and its cap arecorrectly positioned (fig. 12).Extinguishing of burnersTurn the knob clockwise to mark « ». The safetydevice is in place.Do not put anything on the hob that isliable to melt.Electric HotplatesTo switch on a hotplate, turn the relevant controlknob to the required heat setting.The control knob is numbered 0 – 60 – OFF1 – Minimum6 – Maximum.The hob has two types of hotplates:Normal HotplatesWe recommend the plates are switched tomaximum (6) for a short while to boost the plate,and then adjusted to the required setting.Rapid Hotplate (Back left)The rapid hotplates indicated by a red spot, willheat up more quickly than a normal plate.fig. 11Burner capBurnerringThermocouple(safety device)Ignitionfig. 12123 4560fig. 13