Zanussi ZCM 5600 Operating And Installation Instructions

General informationMoving your cookerYou may damage some soft or badly fitted floor coverings when youmove the cooker. The floor covering under the cooker should besecurely fixed so it does not ruck up when you move the cooker acrossit. Alternatively you could remove the floor covering.To move the cooker open the grill door. Raise the cooker off its frontfeet by lifting it from inside the grill. Pull the cooker forward. When youreplace the cooker push it back to the stop and make sure there is thesame gap at each rear corner.Connecting to the electricity supplyThe plug supplied with the cooker can be fitted directly to a suitablethree pin earthed socket.If you have to change the fuse replace it with a 13 amp fuse which hasbeen ASTA approved to BS 1362.Do not use the plug until you have put the fuse cover back on. If thefuse cover is lost you can get a replacement from an electrical retailer.The correct replacement can be identified by marking or colour coding.If you cut the plug off dispose of it safely as it will be a shock hazardif it is inserted into a 13 amp socket elsewhere in the house.38Z C M 5 6 0 0General informationFor your safetyDo not block any of the cooker vents.Never line any part of the cooker with aluminium foil.Don't let items which can catch fire or electric mains leads suchas kettle flexes trail over any part of the cooker.For your safetyDo not try to disconnect the cooker from the gas supply if the supplypipe does not have a bayonet connection, as described in theinstallation instructions. If this is the case contact the person whoinstalled the cooker.For your safetyThis cooker must be earthed and protected by a 13 amp fuse.