Zanussi ZCM 5600 Operating And Installation Instructions

10. CHECKING THE MAIN OVENCONTROLSTO SET THE TIME OF DAY (see Fig.5)1. Turn on the electricity supply and ensure that thethermostat is in the off position.1a. Before setting timer read important note below.2. Rotate the left hand clock knob to manual andback to the clock ' ' position.3. Set the time of day by rotating the right handknob. Note that it is a 24 hour clock.4. Rotate the left hand clock knob back to themanual position.NOTE: When setting the time of day with the selector knob in the clock ' ' position only, this will activatethe timer for seven seconds after selection. This means that when setting the time of day in this function thetime can only be set by using the right hand knob within a seven second period.After seven seconds have elapsed from when the correct time of day has been set, the timer ceases tobe active and subsequent operation of the right hand knob will not change the time setting.When the right hand knob is turned anti-clockwise after the seven second delay period, a choice ofthree audible signals are available. To select the choice of signal required rotate knob anti-clockwise andrelease. Repeat procedure to choose desired signal.11. CHECKING THE MAIN OVEN1. Set the clock as described above, the oven is now ready for manual operation.2. Turn the main oven thermostat to maximum. The oven fan and lamp will operate and after a shortperiod the heat from the oven element may be felt when the oven door is opened.3. Turn off the thermostat and check that the oven fan stops and the oven lamp goes out.12. AUTOMATIC OPERATIONHaving set the clock up as described above, turn the left hand knob to the 'cook time' position and set theright hand knob to show a cooking time of two minutes (0.02).Turn the left hand knob to the 'end time' position; the time shown on the display is now the time of day withtwo minutes added on. Rotate the right hand knob to add two minutes to this time to give a two minute delay.Turn the left hand knob to the 'automatic' position to complete the programming sequence, the clock nowshows the time of day again with 'auto' glowing continuously.Turn the oven thermostat on and two minutes after setting, the oven fan and lamp should operate.Two minutes after the oven starting, the timer should cut off power to the oven and the audible signal shouldsound. The signal is continuous and it may be switched off at any time by rotating the left hand knob.Return timer to manual by rotating the left hand knob to the 'manual' position.13. CHECKING THE MAIN OVEN LIGHTTurn the main oven thermostat knob full on and check that the main oven light is working. Turn off thethermostat.GENERAL NOTEInstruct the user on how to use the appliance and its ignition system.Refer the user to the wording in the inside cover which gives advice on the safe operation of the appliance..Z C M 5 6 0 050Fig.5ZCM5600 - 311336506

/ 52

Related manuals for Zanussi ZCM 5600