17Instructions for the installerThis appliance cannot be positioned on abase.The following instructions are meant for a qualifiedinstaller, in order that the operations of installation,regulation, and service are executed according tothe existing regulations.Before using the unit, take off the special protective layerwhich protects the stainless steel and anodyzed tinparts. Whenever changes are mode involving thedisconnection of the machine it is necessary to proceedwith maximum caution.Positioning and levellingIn order to function normally it is imperative that this unitis installed in a well ventilated kitchen (regarding theinstallation follow the existing regulations). The applianceis of freestanding type and must be installed accordingto the existing regulations.Feet AssemblyBefore installing the cooker, it is necessary toassemble the supplied feet.1. Remove the hob pan supports, the burner caps andcrowns and the oven accessories.2. Carefully lean the cooker on its back, paying attentionnot to cause any damage.3. Adjust the feet height by unscrewing the bottom partof each foot, until you obtain the required height (heightcan be adjusted from 850 to 880 mm).4. Insert the feet into the relevant holes indicated in thediagram.5. Lift the cooker in vertical position. Replace the crowns,the burner caps, the hob pan supports and the ovenaccessories.6. If necessary, adjust the cooker horizontal levelling byturning the bottom part of the feet, until the applianceis completely stable.FO 2283THE MANUFACTURING COMPANY DECLINESANY RESPONSABILITY FOR POSSIBLEDAMAGES RESULTING FROM ANINSTALLATION WHICH DOESN'T COMPLYWITH THE RULES IN FORCECharacteristics of Burners, Nozzles and TapsBurner Nominal Power LPG (Butane "A") Diameter FeedingTap. By-Pass PressurekW kCal/h Nozzle g/h mbar (*)Auxiliary 0,95 814 50 75 28Semi-rapid 1,60 1368 65 126 35 30Rapid 2,45 2095 80 193 45(*) 1 mbar = 10 mm. water coloumn)))))