What to do if…The appliance does not start or stops during operation.If there is a fault, first try to find a solution to the problemyourself. If you cannot find a solution to the problemyourself, contact the Service Force Centre.Caution! Switch off the appliance before you do thebelow suggested corrective actions.Fault code and malfunction Possible cause and solution• continuous flash of the start/cancel in-dicator light• 1 flash of the end indicator lightThe dishwasher does not fill with water• The water tap is blocked or furred with limescale.Clean the water tap.• The water tap is closed.Open the water tap.• The filter in the water inlet hose is blocked.Clean the filter.• The connection of the water inlet hose is not correct. The hose canbe kinked or squashed.Make sure that the connection is correct.• continuous flash of the start/cancel in-dicator light• 2 flashes of the end indicator lightThe dishwasher will not drain• There is a blockage in the sink spigot.Clean the sink spigot.• The connection of the water drain hose is not correct. The hose canbe kinked or squashed.Make sure that the connection is correct.• continuous flash of the start/cancel in-dicator light• 3 flashes of the end indicator lightThe anti-flood device operates• Close the water tap and contact your local Service Force Centre.The programme does not start • The appliance door is not closed.Close the door.• Mains plug is not connected in.Put in the mains.• The fuse has blown out in the household fuse box.Replace the fuse.• Delay start is set.Cancel the delay start to start the programme immediately.After the check, switch on the appliance. The programmecontinues from the point of interruption. If the malfunctionshows again, contact your Service Force Centre.These data are necessary to help you quickly and cor-rectly:• Model (Mod.)• Product number (PNC)• Serial number (S.N.)For these data, refer to the rating plate.Write the necessary data here:Model description : ..........Product number : ..........Serial number : ..........57