Zanussi ZDS 2010 User Manual

Also see for ZDS 2010: User manual User manual User manual

Contents

External cleaningClean the external surfaces of the appliance and controlpanel with a damp soft cloth. Only use neutral detergents.Do not use abrasive products, scouring pads or solvents(acetone, trichloroethylene etc...).Frost precautionsCaution! Do not install the appliance where thetemperature is below 0 °C. The manufacturer is notresponsible for damage because of frost.If not possible, empty the appliance and close the door.Disconnect the water inlet hose and remove water fromthe water inlet hose.What to do if…The appliance does not start or stops during operation.If there is a fault, first try to find a solution to the problemyourself. If you cannot find a solution to the problemyourself, contact the Service Force Centre.Caution! Switch off the appliance before you do thebelow suggested corrective actions.Fault code and malfunction Possible cause and solution• continuous flash of the start/cancel in-dicator light• 1 flash of the end-of-programme indi-cator lightThe dishwasher does not fill with water• The water tap is blocked or furred with limescale.Clean the water tap.• The water tap is closed.Open the water tap.• The filter in the water inlet hose is blocked.Clean the filter.• The connection of the water inlet hose is not correct. The hose canbe kinked or squashed.Make sure that the connection is correct.• continuous flash of the start/cancel in-dicator light• 2 flashes of the end-of-programme in-dicator lightThe dishwasher does not drain• There is a blockage in the sink spigot.Clean the sink spigot.• The connection of the water drain hose is not correct. The hose canbe kinked or squashed.Make sure that the connection is correct.• continuous flash of the start/cancel in-dicator light• 3 flashes of the end-of-programme in-dicator lightThe anti-flood device operates• Close the water tap and contact your local Service Force Centre.12