Zanussi ZDT12002FA User Manual

Contents

Water hardness Water softeneradjustmentGermandegrees(°dH)Frenchdegrees(°fH)mmol/l ClarkedegreesManual Elec-tronic43 - 50 76 - 90 7.6 - 9.0 53 - 63 2 1) 937 - 42 65 - 75 6.5 - 7.5 46 - 52 21) 829 - 36 51 - 64 5.1 - 6.4 36 - 45 21) 723 - 28 40 - 50 4.0 - 5.0 28 - 35 21) 619 - 22 33 - 39 3.3 - 3.9 23 - 27 21) 51)15 - 18 26 - 32 2.6 - 3.2 18 - 22 1 411 - 14 19 - 25 1.9 - 2.5 13 - 17 1 34 - 10 7 - 18 0.7 - 1.8 5 - 12 1 2< 4 < 7 < 0.7 < 5 12) 12)1) Factory position.2) Do not use salt at this level.Manual adjustment1 2Turn the water hard-ness dial to the posi-tion 1 or 2.Electronic adjustment1. Press the on/off button to activate the appli-ance.2. Make sure that the appliance is in settingmode. Refer to ‘SETTING AND STARTINGA PROGRAMME’.3. Press and hold the programme button untilthe programme indicator (A) starts to flashand the programme indicator (B) comes on.4. Wait until the programme indicator (B) goesoff and the end indicator starts to flash (theprogramme indicator (A) continues to flash).5. Press the programme button.• The end indicator flashes intermittently.The number of flashes shows the level ofthe water softener, e.g. 5 flashes +pause + 5 flashes = level 5.6. To adjust the level of the water softener,press the programme button. Each time youpress the programme button you go to thenext level.7. Deactivate the appliance to confirm the set-ting.Filling the salt containerCaution! Only use dishwasher salt. Otherproducts can cause damage to theappliance.Water and salt can come out from the saltcontainer when you fill it. Risk of corrosion. Toprevent it, after you fill the salt container, start aprogramme.20 www.zanussi.com