Zanussi ZDT26022FA User Manual

ADDING DETERGENT212 0 3 0A BIf the programme has a prewash phase, put a small quantity of detergent also in compartment B.ADDING MULTI-TABLETS212 03 0• Adjust the water softener to the lowest level.SETTING AND STARTING A PROGRAMMEThe AUTO OFF functionThis function decreases energy consumption bydeactivating automatically the appliance when it isnot operating.The function comes into operation:• 5 minutes after the completion of theprogramme.• After 5 minutes if the programme has notstarted.Starting a programme1. Keep the appliance door ajar.2. Press the on/off button to activate theappliance. Make sure that the appliance is inprogramme selection mode.3. Press one of the programme buttons until thedisplay shows the number of the desiredprogramme. The display shows the programmeduration after some seconds.4. Set the applicable options.5. Close the appliance door to start theprogramme.Option Delay1. Set a programme.2. Press until the display shows the delay timeyou want to set (1-24h).The delay time flashes in the display.3. Close the appliance door. The countdownstarts to decrease by 1 hour.When the countdown is complete the programmestarts.Option XtraDryActivate this option to boost the dryingperformance. With XtraDry on, the duration of someprogrammes, water consumption and the last rinsetemperature can be affected.XtraDry is a permanent option for all programmesother than Eco and need not to be selected atevery cycle.In the other programmes the setting of XtraDry ispermanent and it is automatically used in nextcycles. This configuration can be changed at anytimeThis option is not available with Rinse and Hold.Option TimeManagerThis option increases the pressure and thetemperature of the water. The washing and thedrying phases are shorter.The total programme duration decreases byapproximately 50%.The washing results are the same as with thenormal programme duration. The drying results candecrease.27